Independent Trading Co. - Nylon Anorak - EXP94NAW


Starting at $53.00
Sizes: XS - 3XL
Log in Here To Order
Independent Trading Co. EXP94NAW Nylon Anorak Model Shot
Color:
Login Here To Order

Register here to access inventory, pricing, and free marketing tools and resources.

Item #: 21976
  • 100% nylon 330D with interior PU waterproof coating
  • Nylon outer shell: waterproof coating = level 3
  • Inner PU coating: breathability/permeability = 5,000
  • Water pressure resistance = 10,000 mm
  • DTM neck taping
  • #5 DTM body coil zipper
  • Matte metal zipper pull
  • Rubber zipper pull tab
  • Zipper garage
  • Single layer body with fine mesh hood liner
  • Matte nickel metal eyelets
  • 3 panel hood
  • Scuba neck
  • Round poly drawcord
  • Hidden snaps inside front pocket flap
  • Side slit pockets
  • Tightening toggle at waistband
  • Elastic cuffs
  • Tear away label

Please Note: Use a nylon or plastisol ink with a catalyst (hardener). Certain Poly Inks can work as well. Ask your ink supplier. Keep in mind a catalyst will shorten the shelf life of the ink leaving left over ink unusable as it will harden.

Use tight screens with 200+ mesh count to lay down a little less ink than would be used on tees (tees normally use a more open mesh like a 110). Ink tends to sit on top of the surface of this fabric as opposed to pressing into cotton type fabrics. A harder squeegee can help lay down less ink and help keep cleaner design edges.

Nylon fabric also tends to move more than tees on the printing pallet. Sometimes a jacket clamp is recommended when doing multi-color prints.

Curing time and temperature will vary by ink types used on nylon fabrics. VERY IMPORTANT to cure your ink at the right temperature without burning or shrinking nylon. Nylon fabrics should usually be cured at temperatures under 320. Flash at low temperatures to keep from burning and/or shrinking fabric. (consult ink supplier and test).

Washing the printed sample garment(s) after 24+ hours (so hardener has set) is recommended to make sure you have proper curing and ink adhesion.

*ALWAYS consult your ink supplier for the right ink, cure temperatures, and curing time. Then run your own test sample(s)
XSSMLXL2XL3XL
Body Length28293031323334
Body Length Tolerance1111111
Chest Tolerance1111111
Chest Width (Laid Flat)21 1/222 1/223 1/224 1/226 27 1/227 1/2
Sleeve Length33 3536 1/43839 1/44142 1/4
Sleeve Tolerance1111111